Contact Us
FOR PATIENTS
SOLEADOCTORS.COM

Demineralization Inhibition by High-Speed Scanning of 9.3µm CO2 Single Laser Pulses Over Enamel

2 MIN READ

Demineralization Inhibition by High-Speed Scanning of 9.3µm CO2 Laser

Ali H. Badreddine, Stephen Couitt, Julia Donovan, Roni Cantor-Balan, Charles Kerbage, and Peter Rechmann

ABSTRACT (Click here for full study)

Objective

In vitro studies were conducted to evaluate the use of an automated system for highspeed scanning of single 9.3 μm CO2 laser pulses in the inhibition of caries-like lesion formation in the enamel of extracted human molars. The effect of the laser in generating an acid-resistant layer and the effect of the layer on inhibiting surface mineral loss during pH cycling was explored.

Methods

Laser irradiation was performed with fluences of 0.6, 0.8, and 1.0 J/cm2 for single pulses of 1mm diameter (1/e2), with pulse durations of 17, 22, and 27 microseconds, respectively. The laser was scanned at a 750Hz pulse repetition rate in an automated pattern covering an area of 7mm2 in 0.3 sec. Six treatment groups were investigated: three groups for each fluence for laser-only and three for laser irradiation with additional fluoride from a toothpaste slurry (sodium fluoride at 1100 ppm). Each group used non-irradiated areas, which included untreated controls for the laser-only groups and a fluoride-only treatment for the groups with additional fluoride. pH cycling was performed on both groups, followed by microhardness testing to determine the relative mineral loss (ΔZ) from a caries-like formation and surface mineral loss (ΔS).

Results

Laser irradiation with the 9.3 μm CO2 laser-generated an acid-resistant layer of about 15 μm in depth. For the laser-irradiated samples with additional fluoride application, the relative mineral loss (ΔZ) was 113 ± 63 vol%-μm, while for those with only fluoride application ΔZ was 572 ± 172 vol%-μm. At the highest fluence (1.0 J/cm2) used, an 80.2% inhibition of caries-like lesion was measured by ΔZ. Using only laser irradiation at the highest fluence resulted in an inhibition of caries-like lesion of 79.5% for the irradiated samples (ΔZ = 374 ± 149 vol%-μm) relative to the control (ΔZ = 1826 ± 325 vol%-μm). Surface microhardness tests resulted in an inhibition of surface softening, as measured by the Knoop Hardness Value (KHN) (108 ± 33 KHN for laser irradiated with additional fluoride, for nonirradiated controls with fluoride only 52 ± 16 KHN). Inhibition of surface loss was observed for all laser fluences, but the maximum surface loss for the untreated control group was only 2.2 ± 0.49 μm.

Conclusions

The results demonstrate a significant benefit of the 9.3 μm CO2 laser at fluences of 0.6, 0.8, and 1.0 J/cm2 in caries‐like lesion inhibition as measured by the relative mineral loss in depth and surface mineral loss, without significant damage to the enamel. Additionally, inhibition of surface softening and surface loss during pH cycling was observed. The surface loss was small compared with the overall lesion depth and thickness of the generated acid‐resistant layer. Lasers Surg. Med. © 2020 Wiley Periodicals LLC

9.3-μm CO2 laser: Carbonate removal and demineralizatio...

Ali Badreddine, PhD Vijayashankar Ramareddy, PhD and Charles Kerbage, PhD

2 min read

Demineralization Inhibition by High-Speed Scanning of 9...

Ali H. Badreddine, Stephen Couitt, Julia Donovan, Roni Cantor-Balan, Charles Kerbage, and Peter Rechmann

2 min read

Request More Information